How do you install and calibrate a limit switch on a control valve?
A limit switch is a device that detects the position of a control valve and sends a signal to a controller or indicator. It is one of the common accessories that can enhance the performance and functionality of a control valve. However, to ensure its accuracy and reliability, you need to install and calibrate it properly. In this article, you will learn how to do that in six easy steps.
Before you install a limit switch, you need to select the appropriate type and model for your control valve. There are different kinds of limit switches, such as mechanical, proximity, magnetic, or optical, and each one has its own advantages and disadvantages. You also need to consider the mounting position, the electrical connection, the environmental conditions, and the compatibility with your control valve and its actuator. Consult the manufacturer's specifications and recommendations to make the best choice.
Once you have the right limit switch, you need to mount it securely on the control valve. Depending on the design of the limit switch and the actuator, you may need to use a bracket, a coupling, or a shaft extension to attach them together. Make sure that the limit switch is aligned with the actuator's rotation or stroke, and that it does not interfere with the valve's operation or maintenance. Tighten the screws or bolts according to the torque values specified by the manufacturer.
After mounting the limit switch, you need to wire it to the power source and the controller or indicator. Follow the wiring diagram provided by the manufacturer and use the appropriate cables and connectors. Make sure that the polarity, voltage, and current ratings are correct and that the wires are insulated and secured. Avoid any loose or exposed wires that could cause short circuits or electric shocks. If the limit switch is installed in a hazardous area, use explosion-proof or intrinsically safe wiring methods.
The next step is to set the switch points, which are the positions of the control valve that trigger the limit switch to send a signal. You can do this by manually moving the control valve to its fully open and fully closed positions, and adjusting the cams or screws on the limit switch until they contact the switches. Alternatively, you can use a digital or analog meter to measure the output signal of the limit switch and adjust it until it matches the desired value.
After setting the switch points, you need to calibrate the limit switch to verify its accuracy and repeatability. You can do this by applying a known input signal to the control valve and measuring the output signal of the limit switch. Compare the measured value with the expected value and calculate the error. If the error is within the acceptable range, then the limit switch is calibrated. If not, you need to repeat the previous step and adjust the switch points until the error is minimized.
The final step is to test the limit switch to ensure its proper functioning and reliability. You can do this by operating the control valve under normal and abnormal conditions, and observing the response of the limit switch. Check if the limit switch sends the correct signal at the right time and if it matches the position of the control valve. Also, check if the limit switch is stable and consistent and if it does not cause any noise or interference. If you find any problems, troubleshoot them and fix them as soon as possible.
-
Prashant Patil
Assistant Manager in Instrumentation Dep. at Worley | Ex-Aker | Ex-TCE | Ex-TCS | Ex-Tata Sons | GGI Impact Fellow
In most cases control valves do not have limit switches in first place. Control valves are used to control flow hence the input is analog input output is in form of flow changes. It is not for On and Off operations. Hence control valves have Position Transmitters instead. It transmit back the exact location of valve stem. Limit switches are used in application which want to know if valve is full open or full close. Mostly control valve is never fully open nor fully closed but is throttling somewhere in middle to control flow. Limit switches are used in On-Off valves.
Rate this article
More relevant reading
-
MechanicsHow can you extend the lifespan of electromechanical relays?
-
Energy EngineeringHow can you test the accuracy of a protective relay?
-
Electrical EngineeringYou need to connect electrical components for an aerospace application. What's the best way to do it?
-
Electrical EngineeringWhat are the best ways to desolder electrical components?